Bsnl broadband modem wireless setup

See to it that physical connections are proper. Now, access the Graphical user interface of modem with IP It will ask for login details. By default, login details for BSNL modem is the same for all users. Other options should be checked as in image below. Check the Radio Button to Always On if you wish to be connected the time your system boots. July 14, at pm.

Harshad Salape says:. July 28, at am. July 28, at pm. Rahul says:. July 29, at pm. July 30, at pm. August 7, at pm. August 9, at pm. August 17, at pm. Debraj says:. August 18, at pm. August 20, at pm. August 25, at pm. August 31, at pm. Shashit Thakur says:. December 26, at pm. Leave a Reply Cancel reply Your email address will not be published.

Recent Posts Popular Posts. Recent How Does Air Purifier work? Stay Updated Bpedia. IP address: Simply Switch off the Modem and Switch on it again to apply the new settings and then move to the next step…. But the screenshot will be of only of Win7.

Everything is done now. Only thing left is making a dial-up connection to your High-Speed Internet. Simply follow these instruction:. Search Search for:. You can make it directly using this tutorial… 1: Configuring your ADSL Modem: This is the most important part and requires only one time customization. This means that the Modem has successfully integrated to your LAN system.

This will take you to the Modem Configuration page. Enter username: admin and password: admin when prompted. Left it to default. I have this under 'Routing - RIP'. I did not put it there, and the available values both have 'Disabled' set, so goes no harm, either way. Under 'DNS', left the value as default, as shown below. IPv6 has not been enabled. I did not put it there, and the virtual post is not enables, so goes no harm, either way.

These should get you up and running if accessing with ethernet cable. Do note that we do not change anything in the PC, none of the IP settings at all. All these changes are only on the modem. Now for wireless to be enabled, this is what I ended up doing. Setting in 'Wireless - Basic' menu: Under 'Security'. Maybe the guru's over here can give me some better way to set this up.

But this is workable. But this one atleast asks for a passkey when a system tries to connect. This is where you set the MAC address of your wireless device to connect.

With 'Disabled' any system can connect, so better to select the 'Allow' option and then click on 'Add' button and give exclusive access. I have just one device connected, as shown below. This is your MAC address and this need to be entered here. And you need to space the value with a colon :.

I didn't know this and did spend some becuase I gave hypen - and it was getting rejected!!! Wireless Bridge values as shown below. Any other option did not let me connect.

I did not change any of these values since I did not get any info about what they are and also I found no reason to change them. Again, request the guru's to say if any changes required here.